This is my first chainsaw that I restored. I have never put gas in it as it has been
stored inside on my mantel for the past couple years.
I powder coated the red and base coat-clear coated the green over top of the painted on decals.
It has all new bearings, seals, gaskets, rings and a re-chromed (Ni Com) cylinder so it is ready to run.
and better than when it was new. The handle bar was polished and a clear powder coat over it to protect it also.
It has a new 60 inch original Homelite bar from the 80's and makes a nice display over the fireplace.


 

It has a new carb kit with new needle and seat and all parts cleaned or re-platted if needed.